Adaptec ASA-7211C/F Adapter Illustrations

1-3

Introduction

Adapter Illustrations

The Adaptec iSCSI adapters are illustrated below. Note the

difference in external connectors. One adapter has a copper

connector; the other, a fibre connector.

ASA-7211C Adapter Card

ASA-7211F Adapter Card

Note: Some ASA-7211 adapters are manufactured with

jumpers “hanging,” but not installed, on jumper connectors J4

and J5. Do not install these jumpers.

Copper

connector

For LED

details, see

Appendix A,

LEDs

Fibre

connector

For LED

details, see

AppendixA,

LEDs

ASA-7211 IG.book Page 3 Tuesday, February 11, 2003 10:04 AM

Contents

Main INSTALLATION GUIDE Page iii Regulatory Compliance Statements Federal Communications Commission Radio Frequency Interference Statem ent European Union Compliance Statement Australian/New Zealand Compliance Statement iv Contents 1 Introduction 2 Installing the Adaptec iSCSI Adapter 3 Installing the Initiator Mode Driver Page Introduction Read This First Adaptec iSCSI Adapter Features Kit Contents Adapter Illustrations System Requirements Hardware Requirements Supported iSCSI targets Operating System Requirements Using the Adaptec iSCSI Installation CD About the Documentation Overview of the Installation Process Installing the Adaptec iSCSI Adapter Page Page Windows 2000 Installing the Driver in Windows2000 Updating the Driver in Windows2000 Page Windows NT 4.0 Installing the Driver in Windows NT 4.0 Updating the Driver in WindowsNT 4.0 Page Red Hat Linux Installing the Red Hat Module Removing the Red Hat Module Enabling Multi-LUN Support in Linux Page Configuring Your iSCSI System Running iConfig on Windows Running iConfig on Red Hat Linux Using Express Setup to Configure Your iSCSI Adapter 4-5 Configuring Your iSCSI System Changing Your iConfig Password For additional information, refer to the iConfig Utility Users Guide. Configuration Tasks A-1 A LEDs The following table describes the LED functionality for the ASA-7211C only. A-2 ASA-7211C/F Installation Guide The following table describes LED functionality for the ASA-7211F only.