Setting Up the PC To Configure the Modem

SETTING UP THE PC TO CONFIGURE THE MODEM

Configure the Megabit Modem 400F using a PC connected to the 10/100BASE-T port. The PC must be set to Specify an IP address to initially access the modem. Enter an IP address for PC NIC card that is on the same subnet as the IP address for the modem. If you want to view or change the default IP address for the modem, see “Using the RS-232 Management Port” on page 57.

The following is an example of how to set up the PC using Microsoft Windows® 95. If you use an operating system other than Windows 95, refer to the appropriate operating system user documentation.

1Open the Control Panel window and double-click on the Network icon shown at right.

2In the Network dialog (shown below), double-click TCP/IP under the

Configuration tab (or highlight TCP/IP then click Properties).

3In the IP Address tab, select Specify an IP address.

4Enter an IP address and subnet mask for the PC, then click OK.

5Restart the PC.

18

Megabit Modem 400F User Manual