CONFIGURATION WORKSHEETS C
This chapter provides worksheets where you can record your system settings and system sessions configuration information prior to executing the procedures in Chapter 4 through Chapter 7.
The information that you need to configure the modem is listed below. Contact your service provider for this information. Use the worksheets in this appendix to record your configuration information. When you begin configuration of the modem in Chapter 4, the procedures refer you to the proper table so you can use the information you have recorded.
CONFIGURATION INFORMATION
1System mode Bridge/Router RFC 1483.
2Bridge/Router:
•Configure as a Bridge only, as a Router only, or as a Bridge and Router.
•If Bridge or Router, choose LLC or
•If Router, choose version of and direction for RIP (RIP1, RIP2, or RIP1 compatible).
•If Bridge, select whether or not to enable Spanning Tree.
3Session address for Ports 1 through 32 (WAN configuration):
•ATM VPI and ATM VCI (specified for each session)
•when using fixed IP addresses, IP address specified for each session by the service provider
Megabit Modem 400F User Manual | 83 |