Setting Up System Options

LTPS-UM-8013-03

 

 

•9600 baud

•No parity

•8 data bits

•1 stop bit

•Hardware flow control to OFF

Maintenance terminal

Serial

COM port

LEC

Craft port

Interface cable

Figure 11. Connecting a Maintenance Terminal to the SCU

The default port configuration for the SCU craft port is CRAFT. Ports 2 and 3 must be configured for CRAFT before the craft interface may be accessed via these ports.

5At the maintenance terminal, press ENTER . The Enter User Name field appears.

CONNECTING A MAINTENANCE TERMINAL TO THE D3RCAM CRAFT PORT

1Locate the D3RCAM in the remote cabinet. The D3RCAM craft port is located on the front of the D3RCAM.

2Select the cable for use between the craft port and the maintenance terminal with a DB-9 (male) connector at one end and a maintenance terminal connector at the other end.

3Connect one end of the interface cable to the maintenance terminal and the other end to the D3RCAM craft port as shown in Figure 12.

4Start a terminal emulation program such as Procomm that emulates a VT100 terminal.

20

August 30, 2002

D3LX CO and RMT Modules