Local Configuration | LTPS-UM-8013-03 |
REMOVING D3LX MODULES
| D3LX | CO |
| STATUS |
| |
| FAR | |
| | END | |
| DS3 | STATUS |
| |
| ENABLE | |
| DS3 | ONLINE |
| |
LEC
Optical receptical
Optical connector
Fiber patch cord
D3LX module
Figure 19. Removing a D3LX Module–D3LX CO Shown
Do not look into the ends of any optical fiber or into any plug-in module connector. Exposure to invisible laser radiation may cause permanent eye damage. A meter should be used to verify active fibers.
1For SC-type connectors: pull down on the retaining latch and withdraw the unit halfway out of the chassis while preventing the fiber-optic cord from binding. Release the fiber-optic patch cord from the optical receptacle by gently pulling back on the locking mechanism and remove the cord as shown in Figure 19.
2For FC-type connectors: unscrew the threaded cap counterclockwise and withdraw the unit halfway out of the chassis while preventing the fiber-optic cord from binding.
3Replace the protective cap on the optical connector located on the circuit board.
32 | August 30, 2002 | D3LX CO and RMT Modules |
