Adcom GTP-860II manual AM Button, 49 M1, M2, M3, M4 Macro Keys, Sleep Button

[47] AM Button

In main and tuner mode, buttons are pre programmed to select the AM band.

[48] FM Button

In main and tuner mode, buttons are pre programmed to select the FM band.

[49] M1, M2, M3, M4 (Macro Keys)

These buttons are programmable for use with any source.

[50] Sleep Button

Press sleep to make the GTP-860II

automatically switch off after a pre- set number of minutes. Pressing the sleep button once will set the sleep time to 90 minutes, after which the GTP-860IIwill automatically switch off into Standby mode. Sleep mode is shown on the Display Panel. To adjust the Sleep Delay, press the sleep but- ton, each consecutive press will reduce the sleep time in 30-minute increments, as shown in the Display Panel. To cancel the sleep mode, con- tinue pressing the sleep button until the sleep time returns to 0 minutes. Pressing the power on the front panel

[1]or Stand-By button will also cancel the sleep mode.

[51] Backlight Button

No programming capabilities. This

button backlights all keys for eight (8) seconds when pressed.

[52] Dim Button

In main mode, button is pre pro- grammed to dim GTP-860II’s informa- tion display.

[53] Main Button

In all modes, button provides access to the GTP-860II. For instance, to turn on the test tone generator first push [53] the main button, then push [39] the test button.

ADCOM GTP-860 II Owner’s Manual 17