Adcom GTP-860IIFront Panel, 1.1Interface Overview, 1.0Description of Unit, Bass/Treble Knobs

GTP-860II Front Panel

[1] Power Button

[2] Tuner Buttons

[3] Display Window

[4] Volume Knob

[5] Headphone/Vid 5 In

[6] Surround Backs

[7] Input Selector

[8] Surround Mode

[9] Bass/Treble Knobs

2 3 2

1

4

5 6 7 8 9

1.0Description of Unit

1.1Interface Overview

The GTP-860II’s front panel is designed for ease of operation. All controls are logically grouped for easy, intuitive operation. Familiarize your- self with the preceding diagram and read the short explanations of each feature below. When you finish, you will be well on your way to enjoy- ing the GTP-860II’s convenience and sound quality.

[1] On/Off Power Switch

Depress the Power button to switch the preamplifier to its On state. The LED in the power button will light up RED. Pressing the Power switch again will turn the unit OFF completely.

If the unit is currently ON, pressing the power button [27] on the remote control, will switch the unit to the standby mode. The front panel indi- cators will turn off except for the LED in the power button which will turn to an amber color. Press the power button on the remote again to switch the unit from the Stand-By state to the On state, and the last selected

source will be indicated in the display.If the preamp is in the Stand- By state, it can be turned On by pressing any of the input selector buttons on the front panel.

NOTE: In Stand-By mode the GTP-860IIuses very little power. However, it is recommended that you switch the unit completely off if it is not going to be used for more than a couple of days. Turn the unit Off by pressing the Power button on the front panel. All lights will extin- guish. When the GTP-860IIis plugged into the wall current may still be flowing into the trans- former. Only when the GTP-860IIis unplugged is all current into the device stopped.

6 ADCOM GTP-860 II Owner’s Manual