automatically logged with test conditions. This logged reading can
be replayed on screen by pressing 
and 1 keys or output to an
Epson compatible printer by pressing 
and 4 keys. It cannot be output to a PC other than via Hyper Terminal. Consecutive records will overwrite each other so must be output to printer before performing another test. After showing the PASS/FAIL the display will immediately revert to current pressure. The instrument must be reset manually for each new test.
PRESSURE TRANSDUCER SELECTION
Models 2024P, 2084P
At 
key (2024P - “0.0” key) and the display will scroll through the available transducer range option,
10.0to 50.0 Bar (in 5 Bar steps) or 55.0 to 500.0 Bar (in 5 Bar steps)
(release to select)
and hold the 
key (2024P - “0.0” key) again to select the required input voltage range, 10.0 to 50.0 Bar with 1 to 50mV (in 1mV steps) or 55.0 to 500.0 Bar with 10 to 50mV (in 1mV steps) (release to select). These are now the default settings.
EXTERNAL PRESSURE TRANSDUCER CONNECTION Pressure range selectable (in Bar) with Sensitivity range selectable (in mV).
Power supplied
+5 Volts (± 0.25 Volts equivalent to 5%)
Wiring instructions
Red Wire = + supply, Blue Wire = - supply,
Green Wire = + signal, Yellow Wire = - signal
WARNING: Care should be taken to ensure the wiring instructions are followed as incorrect wiring of the cable to the transducer may damage the instrument.
USER DEFINED SCALE
Press 
key and NE will appear before the display clears. Enter scale percentage. Only the first two digits entered are valid - this gives a scaling from 1 - 99%. This value will be multiplied into current display to give user defined scale. Press 
to accept. NE will stay displayed and current reading will appear. A downward arrow will indicate that this feature is active.
WARNING - whilst in this mode over range indication (out) is disabled. Do not over pressure the instrument.
INSTRUMENT ACCURACIES
From +20°C to +30°C/+68°F to +86°F 0.1%rdg +0.1%fs +1 digit From
The overall performance of the instrument is obtained by combining the stated accuracy and any uncertainty due to the measurement process.
WARRANTY
This instrument has been carefully assembled and tested, and is warranted against faulty workmanship and materials for two years from the date of purchase.
During the warranty period any defective instrument will be repaired or replaced at the discretion of the manufacturer. This warranty does not cover damage or failure resulting from misuse or accident.
Modification, adjustment or any alteration with the internal arrangement of the instrument shall absolve the manufacturer from any liability in respect of the instrument.
Any instrument to be repaired should be forwarded to the supplier, carriage paid and at the owner’s risk. A brief description of the fault should be included.
