ADT Security Services 3000 manual 0DFUR.H\3URJUDPPLQJ 8VDJH, $ERXW0DFUR.H\V

0DFUR.H\3URJUDPPLQJ 8VDJH

$ERXW0DFUR.H\V

The “A”, “B”, “C” or “D” keys can be used to automatically activate a series of commands of up to 16 keystrokes, if programmed for this function. These keystrokes, as a group, are called “macros” and are stored in the system's memory.

• Typical macro functions can include:

- Arming sequences: STAY, Night-STAY, INSTANT, or AWAY - Bypassing particular zone(s)

- Activating relay(s) for turning on (or off) lights, fans, etc.

• Up to four macros can be assigned – but no more than one macro to a key.

• Macros can be activated only by users with authority levels authorized to perform the macro’s function.

• Macros function only when the system is disarmed.

NOTE: The installer must activate the desired function key (using *57 Function key Menu Mode) before macros can be assigned.

See the chart at the back of this manual for the key(s) assigned for macros.
1.	+ [#] + [6] + [6]	(-7%61)(
	(Security Code)	6%(=83%61
2. Enter the macro number, 1-4, to be programmed at
		7)0)'81%'63	￿
	the “Select Macro?” prompt. Remember, there are
	four macros available, but only one macro can be	￿￿￿
	assigned to each key.
3. If a macro has been previously defined, the
		1%'63(-740%=
	keystrokes are shown on the bottom line of the
	display, otherwise the display is blank.
	To exit this mode (and keep the existing macro
	definition), press any key except the [∗] key. The
	system returns to normal mode.
	To define a macro for the selected key, press [∗] and
	continue with the next prompt.
	Enter the first of the series of desired commands, (do
		1%'634+1
	not include your user code when programming a
	macro), then press/hold the “D” key for at least two
	seconds to complete the first command. This key
	terminates each separate command, and appears as
	an “F” in the touchpad display.

– 23 –