ADT Security Services 3000 manual Qwu\Lw’Hod\V, Qwu\’Hod, Partition

(QWU\([LW’HOD\V

Your system has preset time delays, known as exit delay and entry delay.

([LW’HOD\

Exit delay gives you time to leave through the designated exit door without setting off an alarm. Exit delay begins immediately after arming your system in any arming mode and Custom Display touchpads display the message “You May Exit Now.” When “You may exit now” disappears, the system is fully armed. If programmed, a slow beeping will sound throughout the exit delay period.

Exit Delay Restart. If you wish to open the entry/exit door to let someone in after arming STAY, you can re-start the exit delay at any time – simply press the [✱] key, then let that person in. This avoids having to disarm the system and then re-arm it again.

(QWU\’HOD\

Entry Delays give you time to disarm the system when you re-enter through the designated entrance door. But you must disarm the system before the entry delay period ends, or an alarm will occur. The touchpad beeps during the entry delay period, reminding you to disarm the system. There are two entry delays (if programmed). The first is for your primary entrance and the second can be used for a secondary entrance, where a longer delay is required to walk to the touchpad to disarm the system.

You can also arm the system with no entry delay at all by using the INSTANT arming mode. This mode provides greater security while on the premises or while away for extended periods of time.

See your installer for your delay times.

Partition 1 __________________________________________________________

Exit Delay:

seconds	Entry Delay 1:
	Entry Delay 2:

seconds

seconds

NOTE: Entry/Exit times set for partition 1 also apply to the common zone.

Partition 2 __________________________________________________________

Exit Delay:

seconds Entry Delay 1:

seconds

Entry Delay 2:

seconds

– 12 –