ADT Security Services 3000 manual $Uplqj&Rppdqgv, Mode Press these keys… Touchpad Confirms By…

$UPLQJWKH6\VWHP

$UPLQJ&RPPDQGV

Before arming, close all perimeter doors and windows and make sure the Ready to Arm message is displayed.

Mode	Press these keys…	Touchpad Confirms By…
Stay	security code + [3] (STAY)	• three beeps
		• armed STAY message displayed
		• red ARMED indicator lights
Night-Stay	security code + [3] + [3]	• three beeps
		• NIGHT-STAY message displayed
		• red ARMED indicator lights
Instant	security code + [7] (INSTANT)	• three beeps
		• armed STAY message displayed
		• red ARMED indicator lights
		Note that entry delay is turned off.
Away	security code + [2] (AWAY)	• beeping for duration of exit delay
		• armed AWAY message displayed
		• red ARMED indicator lights
		Leave the premises through an entry/exit
		door during the exit delay period to avoid
		causing an alarm. The touchpad beeps
		rapidly during the last 5 seconds of the
		exit delay to warn you that it is ending.

Quick Arming

If "Quick Arming" was programmed by the installer, the [#] key can be pressed in place of the security code when arming the system. However, the security code

must always be used to disarm the system.

Function Key Arming

For any arming command, a function key may have also been programmed for your system. If so, you can press and hold the appropriate function key for 2 seconds to arm the system. See your installer for the designated functions (see Single Button Arming section).

Refer to the Accessing Other Partitions section for information on multi-partiion arming.

– 15 –