BYPASSING PROTECTION ZONES
Using the
ÊÊ 6 Ê BYPASS Key
All bypasses are removed when an OFF sequence (security code plus OFF) is performed.
TO BYPASS ZONES:
¥ Enter code. |
This key is used when you want to arm your system with one or more zones intentionally unprotected. The system must be disarmed first.
1.Enter your security code and press the BYPASS [6] key.
2.Enter the zone number(s) for the zone(s) to be bypassed (e.g., 06, 10, 13, etc.).
Single digit zone numbers must be preceded by a zero (e.g. 05, 06).
3.When finished, the touchpad will momentarily display a "Bypass" message for each bypassed zone number. Wait for these zones to be displayed, to confirm their bypass.
4.Arm the system as usual.
Bypassed zones are unprotected and will not cause an alarm if violated while your system is armed.
TYPICAL MOMENTARY DISPLAYS | TYPICAL DISPLAYS AFTER ALL BYPASSED |
OF BYPASSED ZONE(S) | ZONES HAVE BEEN DISPLAYED (PRIOR TO ARMING) |
¥ Press BYPASS key. |
¥ Enter zone Nos. |
¥ Wait for bypassed zones |
ÊÊto be displayed. |
¥ Arm system as usual. |
BYPASS 06
BE DROOM WINDOW
CUSTOM DISPLAY TOUCHPAD
DISARMED BYPASS RE ADY TO ARM
CUSTOM DISPLAY TOUCHPAD
Ê06 | AC |
BYPASS |
THE ÒREADYÓ INDICATOR WILL LIGHT TO SIGNIFY THAT THE SYSTEM IS READY TO ARM
AC
BYPASS
ENGLISH DISPLAY TOUCHPAD | ENGLISH DISPLAY TOUCHPAD |
To display bypassed zones prior to arming (see displays above, right), enter your security code and press the BYPASS [6] key. This will also bypass any open zones at that time (if ÒQuick BypassÓ is enabled Ð see following page).
