ADT Security Services Security Manager 2000 Entry/Exit Delays, General Information, Partition

General Information

ENTRY/EXIT DELAYS

Your system has preset time delays, known as exit delay and entry delay. Whenever you arm your system, exit delay gives you time to leave through the designated exit door without setting off an alarm. Exit delay begins immediately after entering any arming command, and applies to all modes of arming protection. If programmed, a slow beeping will sound throughout the exit delay period.

Entry Delays give you time to disarm the system when you re-enter through the designated entrance door. But you must disarm the system before the entry delay period ends, or an alarm will occur. The touchpad beeps during the entry delay period, reminding you to disarm the system. There are two entry delays (if programmed). The first is for your primary entrance and the second can be used for a secondary entrance, where a longer delay is required to walk to the touchpad to disarm the system.

You can also arm the system with no entry delay at all by using the INSTANT arming mode. This mode provides greater security while on the premises or while away for extended periods of time.

See your installer for your delay times.

Partition 1 Exit Delay:

Partition 2 Exit Delay:

Ê Ê Ê Ê Ê

Ê Ê Ê Ê Ê

seconds	Entry Delay 1:
	Entry Delay 2:
seconds	Entry Delay 1:
	Entry Delay 2:

Ê Ê Ê Ê Ê

Ê Ê Ê Ê Ê

Ê Ê Ê Ê Ê

Ê Ê Ê Ê Ê

seconds

seconds

seconds

seconds

Ð 7 Ð