ADT Security Services Security System, Security Manager 2000 user manual Single-Button Paging

SYSTEM OVERVIEW (Continued)

Phone Access &

Voice Response

Capability

Paging Feature

Single-Button Arming Feature

Check with your installer if single-button arming is present in your system.

Your system may include a voice module that will permit you to access the system via a Touch- tone phone, either on-premises or by call-in when away. The phone access feature will enable you to do the following:

¥Receive synthesized voice messages over the telephone regarding the status of the security system.

¥Arm and disarm the system and perform most function commands via the telephone, with voice confirmation provided after each command entry.

Complete information regarding the use of this feature is provided in a separate manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the voice module.

If the paging feature has been programmed for your system, a pager will respond to certain conditions as they occur in your system. The pager will display code numbers indicating the type of condition that has occurred. Refer to the PAGING FEATURE section later in this manual for detailed information.

Single-Button Paging

The touchpads have a special key (identified as the ÒDÓ key) which may be used to signal a Pager. The message displayed on the Pager when this key is pressed is 999–9999. This code could mean Òcall homeÓ, Òcall your officeÓ, or whatever you decide this code will mean. See SINGLE-BUTTON PAGING FEATURE section.

If programmed for your system, keys A and B on the touchpads may have been programmed for single-button arming without the use of a security code, as follows:

Key A, when pressed for 2 seconds, will arm all protection (AWAY mode).

Key B, when pressed for 2 seconds, will arm the perimeter (STAY mode).

Ð 6 Ð