Chapter 2. Installation
12 Express XR/XRT Quick Start Guide 61200.153L1-13
3. In the command line, type a:\setup (where a is the disk
drive where the ADTRAN Express Configuration Wizard
disk was inserted).
4. Follow the screen prompts and insert disk(s) as requested.
Once installation is complete, an ADTRAN program group is
created and placed in the Program Manager. The Express
Configuration Wizard software can be started by double clicking
on the Express Configuration icon in the ADTRAN program
group. The ADTRAN Express Configuration Wizard software
can also be started by double clicking on the Express Configura-
tion icon on the Control Panel.
Get On With It!
Go to the section Using the Express Configuration Wizard.
Basic Telephone Service
In addition to the computer connection, two analog devices such
as a telephone, FAX, modem, answering machine, or caller ID
box can be connected using the two POTS interfaces on the rear
panel (RJ-11 jacks labeled 1 and 2 with a diagram of a telephone
above the jack).
Supplementary Voice Services
Supplementary services such as call forwarding, caller ID, call
return, call holding, three- or six-way conference, call transfer,
and call waiting are fully supported by the Express XR/XRT on a
touch-tone telephone. These services are available only if in-
cluded in the ISDN line configuration and are implemented
using the standard commands provided by the telephone
company.
Call Waiting
Call Waiting permits one voice call to be placed on hold while
answering another voice call. Use the flash-hook to place the
active call on hold and answer an incoming call. Hanging up
terminates both calls. The call waiting tone can be disabled and
enabled using a touch-tone phone as follows:
Disable call waiting: Press ** 0
Enable call waiting: Press ** 1