ADTRAN 3360.9VU01, 1200153L2, 1200153L1, XRT Macintosh Configuration, VT 100 Terminal Emulation

Chapter 2. Installation

14.In the Make a New Connection menu, enter the number to dial.

15.Click NEXT.

16.Click Finish to complete the new connection setup.

17.To use this connection, select it from My Computer, Dial-Up Networking. Windows dials the number using the modem and properties as configured. When using the connection the first time, network log in information such as the user name and password must be entered. This information should be provided from the Internet Service Provider.

MACINTOSH CONFIGURATION

A Macintosh can be used to configure the Express XR/XRT by using a terminal emulation package such as MicroPhone Pro™ and following the VT 100 configuration directions.

VT 100 TERMINAL EMULATION

The Express XR/XRT can be configured using any communica- tions package supporting VT 100 terminal emulation. To enter into the menus, type AT!V Enter. To go to a particular menu, press the hot key sequence for that menu. The main branches of the menu tree and their hot keys are as follows:

STATUS (Ctrl + V)

TEST (Ctrl + T)

CONFIG (Ctrl + C)

DIAL (Ctrl + D)

Ensure that the communications package is configured to pass these Control Sequences through to the Express XR/XRT.

To exit the menus, press Ctrl + X. The Ctrl + X command also places the unit back on-line if a call is connected.

Some features in the Express XR/XRT do not immediately take effect upon selection. This prevents unintentional reconfiguration of the Express XR/XRT during an active call. Items such as Protocol and Call Type take effect only at the beginning of a new call.

61200.153L1-13 Express XR/XRT Quick Start Guide 23