Appendix A. AT Commands and
S42 ... BOND | The number of seconds both endpoints wait for |
TXADD01 | the additional call to be connected at the end of |
| negotiation before deciding the async BOND- |
| ING call has failed. When dialing overseas it |
| may be necessary to lengthen this timer to allow |
| for slower call routing. |
| 0 to 255, 50 sec is default |
S43 ... BOND TXDEQ .. The number of seconds both endpoints attempt to equalize the network delay between the bearer channels before deciding the Async BONDING call has failed.
0 to 255, 50 sec is default
S44 ... BOND TANULL The number of seconds the answering endpoint attempts to detect the Async BONDING negotia- tion pattern from the originating endpoint before aborting to clear channel mode. It may be necessary to shorten this timer if the DTE equipment connected to the Express XR/XRT also has timer constraints for completing non- BONDING parameter negotiation.
0 to 255, 10 sec is default
S45 ... BOND TCID ...... The number of seconds both endpoints attempt
to negotiate agreeable values for bearer channels and channel capacities before deciding the async BONDING call has failed.
0 to 255, 5 sec is default
S52 ... SWITCH TYPE .. Selects the network switch type for dial service.
0= AT&T 5ESS
1= Northern Telecom
2= National
S53 ... | CALL TYPE | Call type (Dial service only). | |
|
| 0 | = Speech |
|
| 1 | = Audio |
|
| 2 | = 56 Kbps data |
|
| 3 | = 64 Kbps data |
S54 ... | PROTOCOL | Rate adaption protocol type. | |
| TYPE | 2 | = Async BONDING |
|
| 6 | = V.120 |
|
| 11 | = FALLBACK |
|
| 12 | = PPP |
60 | Express XR/XRT Quick Start Guide |