Figure | |
Figure 1-1: Dimensions of the PPC-S123 | 8 |
Figure 2-1: Front view of the panel PC | 10 |
Figure 2-2: Rear view of the panel PC | 11 |
Figure 2-3: Rear and bottom view of the panel PC | 11 |
Figure 3-1: Install the HDD on the HDD carrier | 19 |
Figure 3-2: Connect HDD to the HDD cable | 19 |
Figure 3-3: Detach the CPU heat sink | 20 |
Figure 3-4: Place CPU push cover over CPU | 21 |
Figure 3-5: Insert screw driver into the hole | 22 |
Figure 3-6: Push CPU in position | 22 |
Figure 3-7: CPU installation | 23 |
Figure 3-8: Fan cooling with heatsink assembly installation | 24 |
Figure 3-9: Installing the memory module | 25 |
Figure 3-10: Install the riser card | 27 |
Figure 3-11: Install the adapter | 28 |
Figure 4-1: Jumpers on the PPC-S123 motherboard | 32 |
Figure 4-2: Locating connectors on the PPC-S123 motherboard | 34 |
Figure 8-1: Setup program initial screen | 66 |
Figure 8-2: CMOS setup screen | 67 |
Figure 8-3: BIOS features setup screen | 69 |
Figure 8-4: Chipset features setup screen | 73 |
Figure 8-5: Power management setup screen | 75 |
Figure 8-6: PNP/PCI configuration setup screen | 77 |
Figure 8-7: Load BIOS defaults screen | 78 |
Figure 8-8: Integrated peripherals screen | 79 |
Figure 8-9: IDE HDD auto detection screen | 82 |
Figure 8-10: Save and exit setup screen | 83 |
Figure B-1: Disconnect the IDE connector | 106 |
Figure B-2: Remove the fuse | 107 |
Figure B-3: Remove the seven screws on the rear panel | 107 |
Figure B-4: Separate the front and rear panel | 108 |
Figure B-5: Remove the inverter and LCD | 108 |
Figure B-6: Remove the CPU board, power board and | |
touchscreen control board | 109 |