Manuals / Advantek Networks / Computer Equipment / Switch

Advantek Networks ANS-24RV user manual correct icon, and then click “Ok” button

Models: ANS-24RV

1 28

Page 25

Step 2: The Connection windows will appear. Enter terminal “Name”, select	correct icon,
and then click “Ok” button.

Step 3: Select “COM1” in the “Connect using” field and then click “OK”.

Page 25

Image 25

Contents

Model # ANS-24RV 24 Port Fast Ethernet Switch with VLAN and Trunking User ManualCopyright1999 All Rights Reserved FCC WarningCE Mark Warning TrademarksContents 2.9.1 MAC Address Configuration 2.8.2 Class of Service Configuration2.10 Configuration 2.10.1 Configuration Backup/Recovery1.3 Package contents 1.2 Product Features1. Introduction 1.1 General Description1.6 Power Connecting 1.4 Front panel LED indicators1.7 Connecting computers to the switch 1.5 Rear panel1.9 To prolong the operational life of your units 2.1 Configure system network 2. Installing the Fast Ethernet SwitchStep 2 Select “Internet Protocol TCP/IP”, and then click “Properties” 2.2 Login the Web The window below shows the Home page of SmartSwitch 2.3 The SmartSwitch Home overview2.4.1 Authentication Configuration 2.4 AdministratorIn this page, you can set and update the IP Address, Subnet Mask, and 2.4.2 System IP ConfigurationGateway 2.4.3 System Statusbe set to default setting 2.4.4 Load Default Settingprocess is completed, you will see the screen as below1 Click “Control Panel” Æ “System Management Tool” Æ “Service” 2.4.5 Firmware update2 Disable both TFTP server and DHCP server 3 Make Sure the Firewall SettingStep1 Click the “Settings” item and set base Directory 5 Press the “Update” button which is shown on the Web page 2.5 Port Management2.5.1 Port Configuration 2.5.3 Bandwidth Control 2.5.2 Port Mirroring2.5.4 Broadcast Storm Control 2.6.1 Group VLAN Setting 2.6 VLAN Setting2.6.2 Multi to 1 Setting 2.7.1 Trunk Configuration 2.7 Trunk Setting“Destination address” or “SD &DA” 2.8.2 Class of Service Configuration 2.8 QoS Setting2.8.1 Priority Mode Priority”2.9.1 MAC Address Configuration 2.9 MAC Address2.10.1 Configuration Backup/Recovery 2.10 Configuration3.2 Setup HyperTerminal 3.1 Connecting to the Switch Console Port3. Console User Interface correct icon Step 3 Select “COM1” in the “Connect using” field and then click “OK”and then click “Ok” button Page 3.3.2 Load Default Setting 3.3 Configure Switching Hub via COM1 Port 3.3.1 Switch Main MenuAfter you enter the Modular Console, the Switch Main Menu will appear This page allows user to restore default port settingsRestore In the 1st option to 3rd option 1. Restore switch default setting/2to restore default settings

correct icon,

and then click “Ok” button.

Step 3: Select “COM1” in the “Connect using” field and then click “OK”.