22Care and cleaning
Door and glass panels
To clean the door, remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the door
1.Open the door as far as it goes.
2.Fully press clamping levers (A) on the two door hinges.
3.Close the door until the first position (angle approximately 70°).
4.Hold of the door with one hand on each
side and pull it away from the at an up angle.
To install the door follow the procedure in reverse.
The number of glass panels if different for the different models.
CAUTION!
Put the door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1.Remove the door.
2.Hold the door trim (B) on the top edge
of the door at the two sides and push inwards to release the clip seal.
3. Pull the door trim to the front to re- move it.
4.Hold the door glass panels on their top edge one by one and pull them up out of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re- verse. Install the smaller panel first, then the larger.
