AGFA HE/001132 manual Printer SOP Class, N-SET Status Codes, ∙ N-Event-Report, ∙ N-Get

HE/001132	Document No. 001132, Revision 2.0	Page 40 of 92
Agfa HealthCare
	NodeID Livelink : 14140190	14 June, 2007

Table 2.2-29: Supported N-SET Attributes for a Basic Grayscale Image Box

Attribute Name	Tag	Value
Image Position	(2020,0010)	1
Polarity	(2020,0020)	NORMAL, REVERSE
Basic Grayscale Image Sequence	(2020,0110)
>Samples Per Pixel	(0028,0002)	1
>Photometric Interpretation	(0028,0004)	MONOCHROME2
>Rows	(0028,0010)	larger than 0
>Columns	(0028,0011)	larger than 0
>Bits Allocated	(0028,0100)	8 – 16
>Bits Stored	(0028,0101)	8 – 16
>High Bit	(0028,0102)	7 to 15
>Pixel Representation	(0028,0103)	0
>Pixel Data	(7FE0,0010)	A data stream of the pixel samples that comprise the Image.

"Workstation" (SCU) will process the N-SET confirmation and response Status codes. The status codes listed below in Table 2.2-30are recognized:

Table 2.2-30: N-SET Status Codes

Code	Status	Meaning
0000	Success	Normally returned by the SCP AE. Image successfully stored in Image Box
B604	Warning	Image size is larger then Image Box size, the image has been magnified.
B605		Requested Min Density or Max Density outside of printer’s operating range. The printer will
		use its respective minimum or maximum density value instead.
C603	Error	Image size is larger then Image box size
C605		Insufficient memory in printer to store the image.
*	Other Status	Other Dicom error codes result in the failure of the job. Other warnings are not communicated
	codes	to the user.

2.2.2.3.1.3.4Printer SOP Class (1.2.840.10008.5.1.1.16)

The Printer IOD is an abstraction of the hard copy printer and is the basic Information Entity to monitor the status of the printer.

The Printer SOP Instance is created by the SCP during start-up of the hard copy printer and has a well- known SOP Instance UID.

The Printer SOP Class is used to monitor the status of the printer.

"Workstation" (SCU) will accept the following DIMSE services:

∙N-EVENT-REPORT

"Workstation" (SCU) can send the following DIMSE services:

∙N-GET

N-EVENT-REPORTis used to report the changes of the printer status in an asynchronous way.

The SCP uses the N-EVENT-REPORT to inform "Workstation" about each execution change. "Workstation" will return the confirmation of the N-EVENT-REPORT operation.