Operating and Progr am ming
Getting Started
1-3
Getting Started
This section describes the additions, changes, and deletions to the
information that appears in chapter 1 of the 5071A Operating and
Programming manual.
CHAPTER GUIDE
Where to Find Important Topics
In the bulleted list delete:
• Powering Down the 5071A 1-8

The 5071A at a Glance

Connectors
The paragraph immediately following item 8. Sync Input is changed-
(The electrical characteristics of these connectors are the same as the
rear-panel 1 pps Output and Sync Input. See “Rear-Panel Features”
on page 4 and 5 for more information.) The rear-p anel 1 pps outputs
and sync input connectors are absent. The front- panel 1 pps output
and sync input signal characteristics are however accurately
described by items 5 and 6 of Table 1-1 “Connector Des criptions ” in
the Operating and Programming manual.

Rear-Panel Connections

Table 1-1 Connector Descriptions items in the Operating and
Programming manual are changed:
Items 5 and 6 are absent from the rear-panel.
Item 9 is absent.
Item 10 Connector Type is a 5-screw terminal strip.
Item 10 Signal Characteristics are 40-58 Vdc on the rear-p anel
terminal strip dc-power inputs 1 and/or 2 with GND as chassis
ground.
Option 048:
Any TCO Opt ion:
Any TCO Opt ion:
Option 048: