Agilent Technologies 5988-7401EN Changing Single Digits

How to Change a Number Field Operating the Agilent 81133A/81134A Pulse Generator

Agilent 81133A/81134A Pulse Generator User’s Guide, January 2005 25

3Press and rotat e the navig ation kno b to set the least sig nifica nt digit

to change.

NOTE This method is useful for fin e-tuning. It als o changes the va lues in real-

time, so that you can immediately see the changes at the output.

4Rotate the navigation knob to change the value.

5Press the navigation knob once when you are done.

Changing Single Digits

NOTE This procedure can also be used to change the unit of the parameter.

1Focus at the number field by rot ating the navigation knob to the

desired position.

2Press and rotate the navigation knob to select the digit (number or

unit).

NOTE You can also press the arrows next to navigation knob.

3Release the navigation knob.

Now when you rotate it, the number (or the unit) changes.

4Press the navigation knob to set the number (or the unit).

You can now see the changes at the output.

Press

PressPress

Press

Press

PressPress

Press

Press

PressPress

Press

Contents

Main 2 Important Notice WARNING CAUTION Contents Safety Requirements Introduction to the Agilent 81133A/81134A Pulse Generator Operating the Agilent 81133A/81134A Pulse Generator 4 Setting Up Generic and Advanced Signals Setting Up a Clock Signal Setting Up a Pulse Signal Setting Up a Data Pattern Setting Up a Burst Signal Updating the Firmware Troubleshooting Index Page Safety Requirements Safety Summary Environmental Conditions 8 Before Applying Power Ground the Instrument Do not Operate in an Explosive Atmosphere Do not Remove the Instrument Cover Initial Inspection Power Requirements Performance Requirements Ventilation Requirements Page Safety Requirements Declaration of Conformity Declaration of Conformity DECLARATION OF CONFORMITY Page 14 Benefits and Key Features Key Features Overview Front Panel Overview Input and Outputs Page Page Operating the Agilent 81133A/81134A Pulse Generator 20 Navigation through the Pages Page Page How to Change a Number Field Entering New Values 24 Modify Values (Fine-Tu ning) Changing Single Digits Page Setting Up Generic and Advanced Signals Setting Up a Clock Signal Page Page Page Page Page Page Page Setting Up a Pulse Signal 2.5 V 500 mV Pulse Width = 5 ns Period = 20 ns Page Page Page Setting Up a Data Pattern Page Page Page Page Page Setting Up a Burst Signal Page Page Page Page Page Setting Up a Repetitive Burst Signal Page Page Page Page Page Setting Up Signals for a Stressed Eye Diagram Measurement Connecting the Instruments 86100 DCA 81134A Pulse Generator 33250A Arbitrary Waveform Generator Setting Up the 81134A by Using the Graphical User Interface Page Page Setting Up the 33250A Waveform Generator Viewing the Eye Diagram on the 86100 DCA Play with the Settings Using the Agilent 81133A/81134A Pulse Generator Pages of the User Interface Page Combining Parameters for Signal Generation Instrument Modes Page Pattern Modes Signal Modes 111001 RZ R1 NRZ Variable Crossover Clock Sources Page Start Mode Trigger Out Timing of Generated Signals Clock Pulses Data Pattern PRBS Started Burst Repetitive Burst Trigger Out Output Jitter Modulation Saving and Recalling Settings Page Updating the Firmware Prerequisites Page Troubleshooting Page Index Agilent 81133A/81134A Pulse Generator Users Guide, January 2005 89 Index A B C D Index P R S T