Installing Your Analyzer
STEP 4. Configure the Analyzer
5.If you will be using the serial port, adjust the analyzer's baud rate until it is equal to the baud rate set on the peripheral by pressing PLOTTER BAUD RATE or
PRINTER BAUD RATE and the 
and 
front panel keys.
NOTE | The plotter menu is shown as an example. It will only appear if you select | |
|
| . |
| PLOTTER PORT | |
|
|
|
You can set the analyzer to the following baud rates:
• 1200
• 2400
• 4800
• 9600
• 19200
6.Also, if you will be using the serial port, you must toggle the transmission control
XMIT CNTRL (handshaking protocol) until your choice of Xon/Xoff or DTR/DSR appears (equal to the transmission control set on the peripheral). The printer menu is
shown as an example. It will only appear if you select PRINTER PORT .
NOTE | Transmission control for plotters is set programmatically. |
•Xon/Xoff sets transmission on/transmission off (software handshake).
•DTR/DSR sets data terminal ready/data set ready (hardware handshake).
Chapter 1 |
