REMOTE CONTROL
OPERATING TV, CABLE TV, VCR AND CD PLAYER
You can control basic functions of a TV, CABLE TV, VCR and CD player with this remote control.
TO ENTER THE ID CODE OF THE EXTERNAL EQUIPMENT
Before attempting to control them, be sure to enter the ID code of the external equipment to the remote control as follows.
1 Confirm the code number of the external equipment.
See the ID code list in the “APPENDIX” at the end of this manual.
2Press either the TV, CABLE, VCR or CD button in the MODE SELECT area.
NOTE
When entering the ID code of a DSS satellite, press the CABLE button.
3 Press and hold the SET UP button for about 3 seconds.
Confirm that the indicator blinks twice while pressing the SET UP button.
4 Press four DIGIT buttons which correspond to the ID code of the external equipment.
For example, if your CD player is an AIWA unit, the required ID code is 0124 or 0157. In this case, press the DIGIT buttons in the order of “0,” “1,” “2” and “4” (or “0,” “1,” “5” and “7” ).
After the fourth DIGIT button is pressed, the indicator blinks twice indicating that the ID code is correct and is stored on the remote control.
To confirm the stored ID code
You can check the stored ID code by counting the indicator blinking.
1 | Press either the TV, CABLE, VCR or CD button. | CONTROL |
| For example, to check the stored code for CD player, press | |
|
| |
| CD. |
|
2 | Press and hold the SET UP button for about 3 seconds. |
|
3 | Press “9,” “9” and “0.” | REMOTE |
4 | The indicator does not blink. | |
| Press “1,” and count the indicator blinks. |
| |
| For example, in the case that the stored ID is “0157.” |
|
5 | Press “2,” and count the indicator blinks. |
|
| The indicator blinks once. |
|
6 | Press “3,” and count the indicator blinks. |
|
| The indicator blinks five times. |
|
7 | Press “4,” and count the indicator blinks. |
|
| The indicator blinks seven times. |
|
TO CONTROL TV, CABLE TV, VCR AND CD PLAYER
En
1 Press any button in the MODE SELECT area (TV, CABLE, VCR or CD).
The remote control is ready to operate the selected mode equipment.
2 Press one of the buttons indicated above.
For the use of the 0 – 9 and the ENTER buttons, see the instruction manual supplied with the unit to be controlled.
Other buttons indicated above have the same function which you will find on the unit to be controlled.
NOTE
•Reenter the ID code of the external equipment after replacing the batteries of the remote control.
•If there are plural ID codes for external equipment in the “APPENDIX,” try each number listed until you can control the external equipment.
ENGLISH 20
