| ON SCREEN DISPLAY |
| TIMER | ||
|
|
|
|
|
|
| ON SCREEN DISPLAY |
| SETTING THE CLOCK |
| |
The receiver provides an “On Screen Display” function to show the receiver settings on the TV screen. With the TV turned on, when you operate the receiver buttons or remote control buttons, the settings appear on the TV screen as well as the receiver display. The following are examples of the “On Screen Display.”
When turning on the receiver, pressing the function buttons, or tuning in a station
On the right side of the screen, the setting results appear for 5 seconds.
Video V I DEO 1
Audio FM
TAPE OFF MUT I NG
ON
TUNER FREQ 8 7 . 5 0MHz
VOL 1 0
“MUTING ON” continues flashing until MUTING mode is set to off.
When pressing audio effect buttons such as SURROUND, DSP, GEQ,
On the left side of the screen, the audio effect settings appear for 5 seconds.
PRO L OG I C | OFF | |
DSP |
| OFF |
L | L V L | MAX |
R | L V L | MAX |
GEQ |
| OFF |
T - BASS | OFF | |
BBE |
| OFF |
When pressing CLOCK or SLEEP buttons on the remote control
On the left side of the screen, the timer setting and the present time appear for 5 seconds.
NOTE
•The receiver provides an “On Screen Display” function only when the TV is connected to the MONITOR VIDEO (S VIDEO) OUT jack.
•When connecting the S VIDEO OUT and VIDEO OUT terminals at the same time, the unit outputs the OSD data only through the S VIDEO OUT terminal.
When the AC cord is connected for the first time, the clock on the display flashes.
Set the time as follows while the power is off.
1 Press the ENTER button.
The display becomes a little brighter.
2 Within 4 seconds, turn the MULTI JOG to designate the hour and the minute.
The time advances by turning it to the right, and decreases by turning it to the left.
The Nor Mbutton on the main unit is also available. Press the button repeatedly. To change the time rapidly in
3 Press the ENTER button.
The clock starts from 00 seconds.
NOTE
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit is activated, and is not a malfunction.
The power economizing mode can be canceled. See page 7 for details.
To correct the current time
Press the POWER button to turn the unit off. Carry out steps 1 to 3 above.
To display the current time
Press the CLOCK button on the remote control. The clock is displayed for 4 seconds.
When the power is off in the power economizing mode, pressing the ENTER button on the unit also displays the current time for 4 seconds.
To switch to the 24-hour standard
Display the current time, and press the DIGITAL/ANALOG/BAND button on the unit within 4 seconds.
Repeat the same procedure to restore the
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.
