1, 2 and 3 in the illustration correspond to the following details.
3AM antenna | 3FM antenna | 1Speaker system A | 1Speaker system B | ||
|
| Right | Left | Right | Left |
1Sub woofer
2AC outlets
Right Left
1Center speaker
1Surround speakers
PREPARATIONS
Connect front speakers (system A and/or B), a center speaker, surround speakers and sub woofer to the corresponding speaker terminals on the unit:
-the front speaker cords to the FRONT SPEAKERS terminals
-the center speaker cord to the CENTER SPEAKER terminals
-the surround speaker cords to the SURROUND SPEAKERS terminals.
-for more powerful bass, the sub woofer (with a
When connecting the sub woofer, be sure to select the “SUBW ON” (sub woofer on) mode (see page 5).
• Front and center speakers
Use the same impedance for both the front and center speakers. The SPEAKER IMPEDANCE SELECTOR on the rear should be set to the position that matches the impedance value of the front and center speakers.
When using 4 ohm speakers, set the selector to IMP:4Ω. When using 8 ohm speakers, set the selector to IMP:8Ω. Please unplug the AC cord before setting the selector.
The SPEAKER IMPEDANCE SELECTOR has no effect on the SURROUND SPEAKERS terminals and the SUB WOOFER 3 jack. For the surround speakers and sub woofer, use speakers of 8 ohms or more.
To get the proper sound effect, the speaker terminals on the unit and the speaker should be connected with proper polarity; the + terminal on the unit should be connected to the + terminal on the speaker (and – to
NOTE
•Be sure to connect the speaker cords correctly as shown in the illustration on the right column. Improper connections can cause short circuits in the SPEAKER(S) terminals.
•Do not leave objects generating magnetism near the speakers.
Front speakers
Wind the tip of the cord around the terminal. Then tighten the terminal. Check that the cord is connected securely.
Surround speakers
Sub woofer | Center speaker |
En
ENGLISH 4