Aiwa NSX-AV800 Listening To External Sources, Care And Maintenance, Press the VIDEO/AUX button

LISTENING TO EXTERNAL

SOURCES

1

J____	.__	—— ---
,— —_,_		—_.—-

To play equipment connected to the VIDEO/AUX jacks, proceed as follows.

1 Press the VIDEO/AUX button.

VIDEO appears on the display.

2 Play the connected equipment.

To change a source name in the display

When the VIDEO/AUX button is pressed, VIDEO is displayed initially. It can be changed to AUX or TV.

With the power on, press the POWER button while pressing the VIDEO/AUX button.

Repeat the procedure to select one of the names.

To adjust the sound level of the external source

When the sound level of the external source is much higher or much lower than that of other function sources, adjust it as follows.

1Press the VIDEO/AUX button and play the equipment.

2Turn the VI DEO/AUX INPUT LEVEL control on the rear panel until the sound level becomes the same as that of other function sources.

CARE AND MAINTENANCE

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, ~enzine or thinner as these coul~ damage the finish of the unit.

To clean the heads and tape paths

After every 10 hours of use, clean the heads and tape paths with a head cleaning cassette or cotton swab moistened with cleaning fluid or denatured alcohol. (These cleaning kits are commercially available.)

When cleaning with a cotton swab, wipe the recording/playback head, erasure-head (deck 2 only), capstans, and pinchrollers.

/’			--l
I	Playbackhead	Cottonswab	I
	c

Pinchroller	(		I
	Erasurehead	Pin)hroller
I
\ !		\ f

After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the cleaned parts are completely dry before inserting the tapes.

To demagnetize the heads

The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise. After 20 to 30 hours use, demagnetize the heads with any commercially available, demagnetizer.

Care of discs

●When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

●After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

23 ENGLISH