Aiwa NSX-AV800 manual Play with Dolby PRO Logic, Additional Dolby PRO Logic Modes

PLAY WITH DOLBY PRO LOGIC

				DOLBY
kT					LOGIC
,— —	..	—	.	PRO
,.—
a“	=-====–
~an[--
i,~)–	–--–
$:-g’i~%
—	—	—	—
	—. —— .—

1 Start playback of the video source.

2 Press the DOLBY PRO LOGIC button.

NORMAL is selected, and the playback sound has the DOLBY PRO LOGIC effect,

To cancel Dolby Pro Logic mode

Press the DOLBY PRO LOGIC button repeatedly until P-oFF is displayed,

MICROPHONE MIXING

1

4

Two microphones (not supplied) can be connected to this unit, allowing you to sing along to music sources.

Use microphones with mini plugs (03.5 mm, ‘/B inch),

Before connecting a microphone

Set the MIC MIXING control to MIN.

1 Connect your microphones to the MIC 1 and MIC 2 jacks.

ADDITIONAL DOLBY PRO LOGIC MODES

In addition to the NORMAL mode, this unit is also equipped with the PHANTOM and the 3 CH LOGIC modes.

PHANTOM mode: Use this mode when no center speaker is connected, The center channel signals are output through the left and right speakers.

3 CH LOGIC mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds through the front speakers.

To select PHANTOM or 3 CH LOGIC

Press the DOLBY PRO LOGIC button to run through the mode choices for selection in the following sequence,

r NORMAL ~ PHANTOM ~ 3 CH LOGIC

MIC 1 MIC 2

c)o

2 Press one of the function buttons to select the source to be mixed, and play the source.

3 Adjust the volume and tone of the source.

4 Adjust the microphone volume with the MIC MIXING control.

The volume of both microphones is adjusted simultaneously.

To echo the microphone sound

❑

7

I cancel J

10 adjust the balance of connected speaker sound levels

Carry out steps 2 to 4 on page 17.

●Depending on the sound source and/or listening conditions, a surround effect may not be obtained even when the DOLBY PRO LOGIC is on.

●The full DOLBY PRO LOGIC effect cannot be obtained when using software without ❑BIOULEYSURROUNLI mark. In this case, use the SURROUND system instead. (See page 7,)

Press the MANUAL SELECT button on the remote control once and then press the 44 or ➤> button. The display changes as follows.

MAX (maximum) + –3 Q –6 ,,,, –15 + MIN (minimum)

c Make sure the SURROUND and the DOLBY PRO LOGIC are turned off before pressing the MANUAL SELECT button.

To record microphone sound mixed with source sound

Follow the procedure for recording from the sound source (see page 13).

The SYNC DUB button cannot be used for mixing recording.

When not using the microphones

Set the MIC MIXING control to MIN and remove the microphones from the MIC jacks.

ENGLISH 18