Aiwa XD-DV370 operating instructions Dolby DIGITAL/PCM

CONNECTIONS (CONTINUED)

D Connecting to an AV amplifier equipped with a Dolby Digital (AC-3) decoder

Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with a Digital In jack. The supplied video cord is also available instead of the coaxial cord.

to 21 pin scart	TV set
connector

21 pin scart cable (not supplied)

to 21 pin scart connector Rear of the unit

DIGITAL

OUT

OPTICAL

DIGITAL OUT	AUDIO
	OUT
COAXIAL	L
S-VIDEO
	R
	NTSC
	PAL AUTO
OUT	VIDEO
	OUT

to DIGITAL OUT	to DIGITAL OUT
OPTICAL jack	COAXIAL jack

Optical cord (not supplied)

to a digital input jack

or Coaxial cord

(not supplied)to an AC power socket (AC 230 V, 50 Hz)

Amplifier equipped with a Dolby

Digital decorder

Front speaker (L)

Front speaker

(R)

Surround speaker (L) Centre speaker Subwoofer Surround speaker (R)

When your TV set is equipped with an S-video input terminal, see page 17.

Set the setup menu correctly after connecting!

According to the audio equipment and TV set to which the unit is connected, set the “Digital Audio Output” and “TV Aspect” of the setup menu correctly referring to the following below.

See “CHANGING SETUP VALUE” on page 39 in detail.

Digital Audio Output

DOLBY DIGITAL/PCM

TV Aspect

When your TV set is a conventional-screen size TV: 4:3 Letter box

When your TV set is a wide-screen size TV: 16:9 Wide

NOTE

When the picture noise appears while copy-protected DVDs are played, connect the unit directly to a TV set. Do not connect through a VCR, TV/VCR or AV selector.

CAUTION

If the AV amplifier is not equipped with a Dolby Digital decoder, do not select “DOLBY DIGITAL/PCM” in the “Digital Audio Output” when connecting the AV amplifier with an optical or coaxial connecting cord.

Merely attempting to play a DVD may cause a high level of noise which could be harmful to your ears and damage the speakers. In such a case, be sure to select “PCM” in the “Digital Audio Output”.

14