PREPARATIONS
15
E Connecting to an AV amplifier equipped with a DTS decoder
Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with
a Digital In jack. The supplied video cord is also available instead of the coaxial cord.
NOTE
When the picture noise appears while copy-protected DVDs
are played, connect the unit directly to a TV set. Do not
connect through a VCR, TV/VCR or AV selector.
CAUTION
If the AV amplifier is not equipped with a DTS decoder, do
not select “Stream/PCM” in the “Digital Audio Output” when
connecting the AV amplifier with an optical or coaxial
connecting cord.
Merely attempting to play a DVD may cause a high level of
noise which could be harmful to your ears and damage the
speakers.In such a case, be sure to select “PCM” in the
“Digital Audio Output”.
Set the setup menu correctly after connecting!
According to the audio equipment and TV set to which the
unit is connected, set the “Digital Audio Output” and “TV
Aspect” of the setup menu correctly referring to the following
below.
See “CHANGING SETUP VALUE” on page 39 in detail.
Digital Audio Output
Stream/PCM
TV Aspect
When your TV set is a conventional-screen size TV:
4:3 Letter box
When your TV set is a wide-screen size TV:
16:9 Wide
When your TV set is equipped with an S-video input terminal, see page 17.
AUDIO
OUT
VIDEO
OUT
S-VIDEO
DIGITAL OUT
OUT
COAXIAL
L
RNTSC
PAL AUTO
OPTICAL
DIGITAL
OUT
Rear of the unit
to DIGITAL OUT
COAXIAL jack
or Coaxial cord
(not supplied)
Front speaker (R)Front
speaker (L)
Centre speaker Subwoofer Surround speaker (R)
Surround speaker (L)
Optical cord (not supplied)
to DIGITAL OUT
OPTICAL jack
to a digital input jack Amplifier equipped with a
DTS decorder
TV set
21 pin scart cable (not supplied)
to 21 pin scart
connector
to 21 pin scart connector
to an AC power socket
(AC 230 V, 50 Hz)