Aiwa XH-A1000 manual Setting the Clock, Karake, Timer

CLOCK AND TIMER

SETTING THE CLOCK

CLOCK

s

a

MULTI
JOG	f,g
ENTER	a
CLOCK
f,g

When the clock is set, the “:” between the hours and minutes flashes. When the clock setting is canceled due to a power failure, the entire clock display flashes.

1Press CLOCK.

2Within 4 seconds, turn MULTI JOG to designate

the hour and the minute.

Turning MULTI JOG changes both the hour and the minute.

for gis also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

SETTING THE SLEEP TIMER		KARAKE
	SLEEP
		TIMER
MULTI		AND
JOG	f,g	CLOCK
f,g

The unit can be turned off automatically at a specified time.

1Press SLEEP on the remote control.

SLEEP

2Within 4 seconds, turn MULTI JOG or press f

or g to specify the time until the power is En

turned off.

The time changes between 5 and 240 minutes in 5-minute steps.

Specified time

3Press ENTER or a.

The clock starts from 00 seconds.

To view the clock when another display is in the display

Press CLOCK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK and then press s within 4 seconds.

Repeat the same procedure to restore the 12-hour standard. In the 12-hour standard, "AM12:00" indicates midnight and "PM12:00" indicates noon.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

To check the time remaining until the power turns off

Press SLEEP once. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice so that “SLEEPoFF” appears.

NOTE

If the power-economizing mode (page 10) is on, all the display lights turn off when the power is turned off. To view the clock, press CLOCK so that the time is displayed for 4 seconds.

ENGLISH 29