Aiwa XH-A1000 manual Setting the Timer, Adjust the volume, Prepare the source

SETTING THE TIMER

VOLUME	TIMER
Function
buttons	Function
TIMER	buttons
MULTI
JOG	VOL /
ENTER
POWER	f,g
a	a
f,g

5Adjust the volume.

The source sound will play at the volume level set in this step when the power is turned on by the timer.

If the volume level is set to 21 or higher, however, it will automatically be set to 20 when the power is turned on.

6Prepare the source.

To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into the cassette tray. To listen to the radio, select the band and tune in to a station.

7Press POWER to turn off the power.

remains on the display after the power is turned off (timer standby mode) if the power-economizing mode is OFF.

The unit can be turned on at a specified time every day with the	When the timer-on time is reached, the unit turns on and
built-in timer.	begins play with the selected source.

Preparation

Make sure the clock is set correctly.

1Press one of the function buttons to select a source.

2 Press TIMER once so that	appears on the
display.

Time and audio source name flash alternately.

3Within 6 seconds, turn MULTI JOG to designate

the timer-on time, then press ENTER or a.

Turning MULTI JOG changes both the hour and the minute.

for g is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

4Within 4 seconds, turn MULTI JOG to select the

duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5- minute steps.

for g is also available instead of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or a is pressed within 4 seconds after step 4.

To check the timer setting

Press TIMER.

The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 6 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily

Press TIMER repeatedly until disappears and “OFF” is displayed.

To restore the timer standby mode, press TIMER once or twice to display or REC.

Using the unit while the timer is set

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

NOTE

•You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or a in step 3.

• If the power-economizing mode is ON,	is not displayed in
the timer standby mode.

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

30 ENGLISH