Aiwa XH-A1000 manual AI Edit Recording, Press CD and load the discs Press CD EDIT/CHECK once

AI EDIT

AI EDIT RECORDING

CD EDIT/
CHECK
0-9,+10
DISC	CD
DIRECT
PLAY	c/d
q
	f,g
	s

The AI edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track lengths. If necessary, the order of tracks is rearranged so that no track is cut short.

(AI: Artificial Intelligence)

NOTE

The AI edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of either side.

Use the remote control from steps 3 to 6.

1Load the tape into the cassette tray, and press

DOLBY NR to turn Dolby NR on or off.

Load the tape with the side to be recorded on first facing upward.

2Press CD and load the disc(s).

3Press CD EDIT/CHECK once.

The lines of AI EDIT and “AI” light up on the display.

AI

When “PRGM” is selected, press CD EDIT/CHECK again.

4Press DISC DIRECT PLAY, then press one of the numbered buttons 1-3 within 3 seconds to select a disc.

5Press the numbered buttons 0-9 to designate the

tape length.

10 to 99 minutes can be specified.

Example: When using a 60-minute tape, press 6 and 0.

In a few seconds, the tracks to be recorded on each side of the tape are determined.

• f, g and MULTI JOG are also available to designate the tape length.

Tape length	Tape side A
	(facing upward) Selected tracks for side A

6 Press qREC/REC MUTE, and then press				RECORDING
c/d within 2 seconds to start recording.
The tape is rewound to the beginning of the side facing
upward, the lead segment is played through for 10 seconds,
and recording starts. When recording on the side facing
upward (side A) ends, recording on the other side (side B)
starts.
To stop recording
Press s. Recording and CD play stop simultaneously.
To clear the edit program
Press s twice so that the line of EDIT disappears from the
display.
To check the order of the edit program
Before recording, press CD EDIT/CHECK to select side A or B,
and press f or g repeatedly.
	Track	Program	Programmed
Tape side number		number	track numbers

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment.

1	Press CD EDIT/CHECK to select side A or B.
2	Press DISC DIRECT PLAY, then press one of the numbered	En
	buttons 1-3within 3 seconds to select a disc.

3Press the numbered buttons 0-9and +10 to select tracks. A track whose playing time is longer than the remaining time cannot be programmed.

4Repeat steps 2 and 3 to add more tracks.

5Start recording.

The line of AI lights off and the line of PRGM lights up.

Time on cassette tapes and editing time

The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape’s specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark).

NOTE

•Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.

•The AI edit function cannot be used with discs containing 31 tracks or more. “TR OVER” is displayed if this is attempted.

Remaining time of side A ENGLISH 21