TIMER RECORDING

Timer recording is applicable for TUNER, VIDEO1/2/3 and AUX/ PHONO/5.1CH (with an external timer) sources only.

Press either TUNER/BAND, VIDEO1/2/3 or AUX/PHONO/ 5.1CH to select a source, then press TIMER repeatedly until

REC appears on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and load the tape to be recorded on into the cassette tray after step 6.

NOTE

If the timer recording is done with the economizing mode (page 10) set to “ECO ON” or "ECO AUTO" and the power turns off, the dimmer mode will be set to “DIMMER 3” and the volume level will be 0 (minimum) level) the next time the power is turned on.

You cannot use the timer function to record from a CD.

You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or a within 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting.

GENERAL

 

 

 

TIMER

CARE AND MAINTENANCE

 

 

 

Occasional care and maintenance of the unit and the software

AND

 

are needed to optimize the performance of your unit.

CLOCK

To clean the cabinet

 

Use a soft dry cloth.

 

If the surfaces are extremely dirty, use a soft cloth lightly

 

moistened with mild detergent solution. Do not use strong

GENERAL

When the tape heads are dirty;

solvents, such as alcohol, benzine or thinner as these could

 

damage the finish of the unit.

 

To clean the tape heads

 

- high frequency sound is not emitted

 

- the sound is not adequately high

 

- the sound is off-balance

 

- the tape cannot be erased

 

- the tape cannot be recorded on

 

After every 10 hours of use, clean the tape heads with a head

 

cleaning cassette.

 

Refer to the instructions of the cleaning cassette for details.

 

To demagnetize the tape heads

 

The tape heads may become magnetized after long-term use.

 

This may narrow the output range of recorded tapes and increase

 

noise.

 

After every 20 to 30 hours of use, demagnetize the tape heads

 

with a separately sold demagnetizing cassette.

 

Refer to the instructions of the demagnetizing cassette for details.

 

 

 

 

Care of discs

En

When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.

Care of tapes

Store tapes in their cases after use.

Do not leave tapes near magnets, motors, television sets, or any source of magnetism.This will downgrade the sound quality and cause noise.

Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

ENGLISH 31

Page 32
Image 32
Aiwa XH-A1000 manual Care and Maintenance, Timer Recording, Clock