Aiwa XH-A1000 manual Connecting A Dvd Player, Selecting External Audio/Video Sources, English

SELECTING EXTERNAL AUDIO/VIDEO SOURCES

AUX/PHONO/5.1CH

VIDEO 1/2/3

f,g

To play equipment connected to the unit, proceed as follows.

1 Press VIDEO1/2/3 or AUX/PHONO/5.1CH repeatedly to select a desired source.

The source names are displayed cyclically as below.

When VIDEO1/2/3 is pressed

VIDEO1 VIDEO2 VIDEO3

When AUX/PHONO/5.1CH is pressed

AUX 5.1chIN∗ PHONO

Select one of the sources depending on the equipment connected to the input terminals on the unit.

∗While the headphones are plugged in, 5.1chIN is not displayed.

2Play the connected equipment.

To monitor a video source

The selected video source is indicated on the display and the video signal through MONITOR/VIDEO OUT jack is output on the TV.

To adjust the sound level of equipments connected to the input jacks (except a equipment connected to PHONO jacks)

When the sound level of the external source is much higher or much lower than that of other function sources, adjust it as follows.

1Press VIDEO1/2/3 or AUX/PHONO/5.1CH repeatedly so that the name of the jacks connected with the concerned equipment is displayed.

Example: To adjust the sound level of equipment connectedto VIDEO 1, press VIDEO1/2/3 repeatedly to display VIDEO1.

2Play the equipment.

3Press f or g until the sound level becomes the same as that of other function sources.

NOTE

•During recording, the sound level can not be adjusted.

•The sound level of the connected turntable cannot be adjusted.

CONNECTING A DVD PLAYER

5.1CH INPUT jacks of this unit support the DOLBY DIGITAL SURROUND system (see page 25).

Connect a DVD player with 5.1ch output jacks to this unit using cables with RCA phono plugs as follows:

This unit’s jack	DVD player’s jack
5.1CH INPUT FRONT (L, R)	5.1CH OUTPUT FRONT (L, R), etc.
5.1CH INPUT SURROUND (L, R)	5.1CH OUTPUT SURROUND (L, R), etc.
5.1CH INPUT CENTER	5.1CH OUTPUT CENTER, etc.
5.1CH INPUT SUB WOOFER	5.1CH OUTPUT SUB WOOFER, etc.
VIDEO/AUX IN (L, R)	LINE OUT (L, R), etc.
		(See	NOTE	.)

NOTE

•If the DVD player is not connected to AUX IN jacks:

-the spectrum analyzer does not show the sound level of the DVD player.

-the sound from the connected DVD player cannot be recorded. To remove these limitations, connect LINE OUT jacks of the DVD player to AUX IN jacks of this unit besides connecting to 5.1CH INPUT jacks.

The signals through AUX IN jacks enable the spectrum analyzer to work and the recording to be done.

Refer also to the operating instructions of the DVD player.

•The DOLBY DIGITAL SURROUND sound cannot be recorded in any way.

8 ENGLISH