![USING THE REMOTE CONTROL](/images/new-backgrounds/202882/20288213x1.webp)
USING THE REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and insert two R03 (size AAA) batteries.
SETTING THE CLOCK
POWER
When to replace the batteries
The maximum operational distance between the remote control and the sensor on the CD player unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones.
Opening and closing the top cover
When to use the remote control
Some operations can be performed using the buttons on the remote control only, while others can be performed using the buttons on the two main units as well as on the remote control.
This instructions manual clearly describes the buttons available for each operation.
m
●If the unit is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.
●The remote control may not operate correctly when:
-The line of sight between the remote control and the remote sensor (see the illustration on the previous page) is exposed to intense light, such as direct sunlight.
-Other remote controls are used nearby (television, etc.)
SHIFT
To use the SHIFT button
Buttons C! have two different functions. One of the functions is indicated on the button, and the other on the plate above the button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the button while pressing the SHIFT button,
+I ❑
II
~d
Press the POWER kwtton to turn on the power.
Press the CLOCK button while pressing the SHIFT button on the remote control.
Within 4 seconds, press the II button,,
The hour flashes.
.,
To restore the
4 Press the + or ~- button to designate the hour,
5 Press the 1I button to set the hour.
The hour stops flashing and the minute starts flashing.
6 Press the ++ or ~~ button to designate the minute.
7 Press the II button to set the minute and complete the setting.
The minute stops flashing on the display and the clock starts from 00 seconds.
To display the current time
Press the CLOCK button while pressing the SHIFT button on the remote control. The time is displayed for 4 seconds.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 12 hours, all settings stored in memory after purchase need to be reset.
ENGLISH 7