
OPERATION
6.3 Setting Mowing Height-Pull Type
1.Park the tractor and mower on level ground.
2.Using the tailwheel ratchet jack or hydraulic cylinder, position the mower so the skid shoes are 1” less off the ground than the desired final cut height. For example, if a 3” cut is desired, raise or lower the mower until the skid shoes are 2” off the ground. If a hydraulic cylinder is used, stroke control spacers can be placed on the hydraulic shaft to maintain a set cutting height each time the mower is raised and lowered.
3.Adjust the mower leveling rod so that the front of the mower is approximately 3/4” lower than the rear.
4.If the mower is attached to a
260/272/284 01/11 | Operation Section |
© 2011 Alamo Group Inc.
OPERATION