Alamo 272, 260 manual DUAL TAIL WHEEL INSTALLATION - LIFT TYPE Model 284 Only, Assembly

ASSEMBLY

ASSEMBLY

DUAL TAIL WHEEL INSTALLATION - LIFT TYPE (Model 284 Only)

1.Attach the tailwheel beam (1) to the lug toward the outer edge of the deck just to the rear of the cross reinforcement using bolt (2) and nut (3). Note: Slide position bracket (4) onto beam before installing.

2.Attach the brackets (5) to the deck using bolts

(29)and nuts (30). Insert bolt (29) through holes in brackets (5) and (4) which will give approximate desired cutting height. Install locknut (30) and tighten all bolts.

A-FRAME INSTALLATION (Quick Hitch) (Model 260 & 272)

1.Attach the A-Frame Bars (2) to the right and left Hitch Lugs (14 & 15) with two 5/8” x 2” bolts (16), 5/8” washers (17), bushing (18) and 5/8” locknuts (19) Figure Asm-R-0342.

2.Attach the Lift Strap Bars (1) to the Mainframe with two 5/8” bolts (16), 5/8” flatwasher (17), bushing (18) and 5/8” locknut (19) Figure Asm-R-0341.

3.Attach flex links (3) to A-Frame bars (2) with 5/8” x 3” carriage bolts (7), bushings (8), flatwasher (9) and nut (10).

4.Insert quick hitch bushing (5) between A-Frame and insert 5/8” x 4-1/2” bolt (4) and 3/4” locknut (6).

5.Insert 5/8” x 2-3/4 bolt (11) through center holes in flex links (3) with bushing (12) through forward holes in rear braces (1).

6.Insert bolt (13) through 2nd hole from front in rear braces (1) and secure with locknut (10).

7.Insert 5/8” x 2-3/4” bolt (11) through rear holes in flex links (3) through bushing (12) with bushing over or on top of rear braces (1).

260/272/284 01/11 Assembly Section 3-4

© 2011 Alamo Group Inc.