Installing the PolicyAssistant and the Policy Flow EditorServer Management Tool Command Set
................................................................................................................................... .........................................................................................................................
365-360-001 R6.0
Issue 1, December 2008 3-15
.................................................................................................................................... ........................................................................................................................
Figure 3-13 SMT–Policy Flow Installation success message
6. Click OK and close the SMT GUI and restart the application.
7. After you restart, instead of the PolicyFlow Editor, you will see the entry Policy
Assistant in the Navigation pane under the Configuration Tools section.
Read through Chapter 9, “Using the 8950 AAA Policy Assistant in Server Management
Tool” for more information on the PolicyAssistant. While the PolicyAssistant is very easy
to use, there are some decisions you must make to successfully set up 8950 AAA.
Installing PolicyFlow Editor
1. To enable the PolicyFlow Editor, perform the following steps:
2. In the PolicyAssistant panel, click Install PolicyFlow.. to open the PolicyFlow
Installation page. The PolicyFlow Installation page is displayed as shown in
Figure 3-10.
3. Select Build Your Own PolicyFlow and click the Install Policy Flow button. A
warning message, as shown Figure 3-11 appears.
4. Click Yes to continue.
5. If the Policy Flow Editor is already installed, one more warning message as shown
Figure 3-12 appears.
6. Click Yes to continue. It will take a few seconds and when the installation is complete,
the following message appears.
Figure 3-14 SMT-Policy Flow Installation success message
7. Click OK and close the SMT GUI and restart the application.
8. Once you restart, you will see that instead of the Policy Assistant, you will see the
entry Policy Flow Editor in the Navigation pane under the Configuration Tools
section.
Read through Chapter 8, “Using the 8950 AAA Policy Flow Editor” for more information
on the PolicyFlow Editor.