Alliance Laundry Systems D677I Meter Case, Timer Cams, GAS DRYERS, ELECTRIC DRYERS, (Metered Models), Coin Drawer Security, 1/4 turn lock is used, (Coin Slide Models Only)

Meter Case(Metered Models)

The factory mounted coin meter case does not include the service door lock, coin drawer, coin drawer lock and keys. These parts must be ordered (at extra cost) according to the purchaser’s requirements direct from the manufacturer of your choice.

NOTE: You have the option of using a screw type lock or a 1/4 turn lock on the meter case service door. If you choose to use a screw lock, then the special bracket (located inside the meter case) must be used. DO NOT use the special bracket if a

1/4 turn lock is used.

Coin Drawer Security – for additional security, drill out the two pilot holes on each front side of the meter case to 1/4 or 5/16 inch (6.4 or 8.0 mm) holes and install a bicycle lock through these holes.

Timer Cams(Coin Slide Models Only)

The dryer timer is factory equipped with a 45 minute timing cam. If this drying time is not suitable to your installation, the following cams can be found in the envelope located in the cylinder.

ELECTRIC DRYERS

1-53242 Cam (30 Minutes)

1-53240 Cam (60 Minutes)

GAS DRYERS

1-53242 Cam (30 Minutes)

A 60 minute timing cam, Part No. 53240, is available for the gas dryer as optional equipment at extra cost.

To change the timing cam:

1.Align notch in cam with a tooth on ratchet wheel.

2.Squeeze the ends of the two timing cam prongs together.

3.Carefully lift timing cam off post.

Installation

NOTE: Adjust ratchet wheel and timing cam to “OFF” position prior to putting dryer into use. Refer to Figure 1 for proper position.

1

6

5

42

3

D775I

7

D775I

1Retaining Prongs

2Timing Cam

3Notch

4Levers

5Off Position

6Ratchet Wheel

7On Position

Figure 1

510969 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 11