Heat Source Check

Electric Dryers

Metered Models

Set the proper FABRIC SELECTOR switch at NORMAL. Place coins in the slide and carefully push slide in as far as possible. IN USE light will come on indicating the dryer is ready to operate. Close the loading door and press the PUSH-TO-START button firmly to start the dryer. After the dryer has operated for three minutes, the exhaust air or exhaust pipe should be warm.

Nonmetered Models

Set FABRIC SELECTOR switch at NORMAL and turn timer knob to 50. Close the loading door and press the PUSH-TO-START button. IN USE light will come on indicating start of cycle. After the dryer has operated for three minutes, the exhaust air or exhaust pipe should be warm.

Installation

Gas Dryers

During the gas heat check, observe the burner flame. The flame can be viewed by removing the lower front panel of the dryer.

Metered Models

Set FABRIC SELECTOR switch at NORMAL. Place coins in the slide and carefully push slide in as far as possible. IN USE light will come on indicating the dryer is ready to operate. Close the loading door and press the PUSH-TO-START button firmly. The dryer will start, the igniter will glow red and the main burner will ignite.

Nonmetered Models

Set FABRIC SELECTOR switch at NORMAL and turn timer knob to 50. Close the loading door and press the PUSH-TO-START button. IN USE light will come on indicating start of cycle, igniter will glow red and main burner will ignite.

IMPORTANT: If all air is not purged out of the gas line, the gas igniter may go off before the gas is ignited. If this happens, after approximately two minutes the igniter will again attempt gas ignition.

510969

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

21