Alliance Laundry Systems D677I ESD Coin Slide, Long Vault Slide Extension, For Greenwald and ESD coin slides:, GREENWALD Comet Slide, GREENWALD Tokette Slide or MONARCH Coin Slide

3

2

1

4

DRY1925N

Installation

Long Vault Slide Extension

WARNING

To reduce the risk of electric shock, fire, explosion, serious injury or death:

•Disconnect electric power to the dryer(s) before servicing.

•Close gas shut-off valve to gas dryer(s) before servicing.

•Never start the dryer(s) with any guards/ panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the dryer is properly grounded.

W001R1

1. Remove the coin slide out through front of meter

case.

1Coin Slide

2Slide Extension

3Accumulator Actuator Arm

4Slide Extension Modifier

Figure 3

5.After completing the dryer check, reinstall service door on top of meter case.

NOTE: When reinstalling service door, front of door must be inserted at about a 45° angle in order to engage notched tabs with internal rib at top of meter case.

2. For Comet, Tokette and Monarch coin slides:

Assemble the slide extension, No. 506114, to the

top side of the coin slide using the two Phillips

head screws and lockwashers, No. 511419, and

tighten firmly. Refer to Figure 4.

For Greenwald and ESD coin slides:

Assemble the slide extension, No. 506114, to the

bottom side of the coin slide using the two Phillips

head screws and lockwashers, No. 511419, and

tighten firmly. Refer to Figure 4.

3. Install slide extension modifier, No. 501796, as

follows:

NOTE: Dryers equipped with a Greenwald coin slide (except for the Greenwald Comet Slide or the Greenwald Tokette slide) do not require the use of the slide extension modifier.

●ESD Coin Slide – Mount the slide extension modifier, No. 501796, to the underside of the slide extension, No. 506114. Align the hole in the slide extension modifier with hole “A” in the slide extension and install the self-tapping screw, No. 501086, and tighten firmly. Refer to Figure 4.

●GREENWALD Comet Slide, GREENWALD Tokette Slide or MONARCH Coin Slide – Mount the slide extension modifier, No. 501796, to the underside of the slide extension,

No. 506114. Align the hole in the slide extension modifier with hole “B” in the slide extension and install the self-tapping screw, No. 501086, and tighten firmly. Refer to Figure 4.

510969 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 13