Alliance Laundry Systems D677I Location Requirements

Location Requirements

Select a location with a solid floor. Dryers installed in residential garages must be elevated 18 inches (46 cm) above the floor.

No other fuel burning appliance should be installed in the same closet with the dryer.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Installation

Leveling legs can be adjusted from inside the dryer with a 1/4" driver. All four legs must rest firmly on the floor so the weight of the dryer is evenly distributed. The dryer must not rock.

The dryer needs sufficient clearance and an adequate air supply for proper operation and ventilation, and for easier installation and servicing. (Minimum clearances are shown in Figure 25).

						F
B			1
						2 (G)
				E
				D
				A	**42"
				(106.7 cm)
						F
	A	A	C
						D337I
	FRONT VIEW		SIDE VIEW		3	FRONT VIEW
	(w/o Closet Door)					(Closet Door)
			Free Standing/Alcove			Closet Installation
Area		Description		Installation
						(Refer to Illustration)
			(Refer to Illustration)
A	Dryer sides and rear clearance			0" (0 cm)		0" (0 cm)
B	Dryer top clearance			12" (30.5 cm)		12" (30.5 cm)
C	Dryer front clearance			Not Applicable		2" (5.1 cm)
D	Exhaust duct clearance to combustible material			2" (5.1 cm)		2" (5.1 cm)
E	Weather hood to ground clearance			12" (30.5 cm)		12" (30.5 cm)
F	Distance from floor or ceiling to hole edge			Not Applicable		3" (7.6 cm)
G*	Area of centered air openings in closet door			Not Applicable		40 sq. in./open (260 sq. cm)

*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown.)

**NOTE: For new installations, locate top of wall vent 42 inches (106.7 cm) above floor to make venting easier to connect.

D337I

1 Closet Door 3 Outer Wall of Enclosure

2Centered Air Openings (Two openings minimum)

Figure 25

510969 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 35