Installation

Dryer Slide Extension

(Coin Slide Models Only)

Short Vault Slide Extension

WARNING

To reduce the risk of electric shock, fire, explosion, serious injury or death:•Disconnect electric power to the dryer(s) before servicing.•Close gas shut-off valve to gas dryer(s) before servicing.•Never start the dryer(s) with any guards/ panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the dryer is properly grounded.

W001R1

1.Assemble coin slide extension, No. 503733, to top side of coin slide using two Phillips head screws and lockwashers, No. 03950. Tighten firmly. Refer to Figure 2.

2.Install slide extension modifier, No. 501796, as follows:

NOTE: Dryers equipped with Greenwald coin slides (except for Greenwald Comet Slide or Greenwald Tokette Slide) do not require the use of the slide extension modifier.

●ESD Coin Slide – Mount slide extension modifier, No. 501796, to the underside of slide extension, No. 503733. Align the hole in the slide extension modifer with hole “A” in the slide extension and install self-tapping screw, No. 501086. Tighten firmly. Refer to Figure 2.

●GREENWALD Comet Slide, GREENWALD Tokette Slide or MONARCH Coin Slide – Mount slide extension modifier, No. 501796, to the underside of slide extension, No. 503733. Align the hole in the slide extension modifier with hole “B” in the slide extension and install self-tapping screw, No. 501086. Tighten firmly. Refer to Figure 2.

1

2

3

4

5

7

6

D019K

1501086 Self-Tapping Screw

2501796 Slide Extension Modifier

3Hole “A”

4Hole “B”

5503733 Slide Extension

6Coin Slide

703950 Phillips Head Screws and Lockwashers

Figure 2

3.Reinstall coin slide in dryer meter case.

4.CHECK DRYER OPERATION – Connect electrical power to dryer. Place required number of coins in coin slide. Push slide in, and observe through service door opening in meter case. The slide extension should be contacting the accumulator actuator arm and moving back with slide travel.

When slide is pushed all the way in, slide is retracted. Accumulator actuator arm should remain back until slide extension is moved forward and contacts actuator arm again, returning arm to starting position. Refer to Figure 3.

12

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

510969