Installation

Additional Dryer Security

Located on the service door of the dryer is a flat Phillips head screw. During shipment, this screw is used to attach the service door to the meter case. For additional security, this screw can be reinstalled inside the control hood of your dryer. Following is the procedure for installing this screw:

1. Remove the Phillips head screw from service door. (Refer to Figure 6.)

2. Remove two screws holding control panel to control hood.

3.Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top.

4.Insert Phillips head screw down through double

1

“D” hole in left rear corner of cabinet top (inside control hood) until it engages retainer nut located on left rear corner gusset of cabinet.

5. Finger tighten screw.

1 Double “D” Hole

IMPORTANT: Do not use a power driver to

tighten screw. Torque of a power driver could over-Figure 6 tighten screw causing damage to cabinet assembly.

D687I

D687I

510969

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

15