1.Install a fused disconnect switch, or a circuit breaker, as close to the tumbler as possible. If more than one stacked tumbler is being installed, provide a disconnect switch or circuit breaker for each. This will make it possible to individually disconnect stacked tumblers for maintenance purposes.

2.Connect the conduit-encased leads to the disconnect switch, or circuit breaker. Remove the screw holding the upper junction box cover to the upper junction box. Refer to Figure 10. Insert the other end of conduit through the hole in the top of the junction box. Connect the wire leads to the appropriate terminals of the terminal block

(L1 and L2 or L1 and N). If the electrical service is 120 Volt, connect the neutral wire to NEUTRAL. The ground wire must be connected to the green ground screw located in the junction box. Refer to Figure 10.

3.Reinstall cover on the junction box.

Installation Instructions

Grounding Instructions

This drying tumbler must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electronic shock by providing a path of least resistance for electric current. This dryer must be connected to a grounded metal, permanent wiring system or to the ground screw (located in the junction box).

WARNING

To reduce the risk of fire and electric shock, check with a qualified serviceperson for proper grounding procedures. Improper connection of the equipment grounding conductor may result in a risk of electric shock.

W068R1

IEI

Board

 

Terminal

 

Jumper

 

Block

Terminal

Ground

Screw

Block

 

TMB2161N

Figure 10

M412060

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

23