Alliance Laundry Systems Stacked Drying Tumbler Operating Instructions, To reduce the risk of fire:

Operating Instructions

The following steps outline the procedure for operating the tumbler through a complete drying cycle.

WARNING

To reduce the risk of fire:

•DO NOT DRY articles containing foam rubber or similarly textured rubberlike materials.

•DO NOT DRY plastics, anything containing wax or chemicals such as mops and cleaning cloths, or anything dry-cleaned at home with a dry-cleaning solvent.

•DO NOT TUMBLE fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

W076

IMPORTANT: DO NOT TUMBLE fiberglass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass.

Always follow the fabric care instructions supplied by the garment manufacturer.

NOTE: Electrical power to the tumbler must be on. The AVAILABLE light will be lit. Refer to Figure 14.

WARNING

To reduce the risk of serious injury, allow cylinder to stop before cleaning lint screen.

W412

1.Energize the electrical circuit to the tumbler at the disconnect switch or the circuit breaker.

2.Open the lint drawer and check for any accumulated lint on lint screen. Close drawer tightly against tumbler front panel and lock drawer securely.

IMPORTANT: Failure to tightly close lint drawer will result in the tumbler not starting.

3.Open the loading door and load the cylinder with laundry. The unit is designed for a 30 pound cotton load (dry maximum load). DO NOT overload! Overloading will result in excessive drying time, wrinkled laundry and wear to cylinder bearings or rollers.

4.Refer to Section IV of the Electronic Control manual for further instructions on how to operate the stacked tumbler. The Electronic Control manual is supplied with the tumbler.

M412060