Alliance Laundry Systems Stacked Drying Tumbler Operating Checks, Electronic Control, Preliminary Operating Check

Operating Checks

Electronic Control

The stacked tumbler comes equipped with an Electronic Control. The Electronic Control gives the owner a variety of programming options. To learn how to use the Electronic Control in more detail, consult the supplemental manual provided with this machine.

Preliminary Operating Check

1.Remove or open all panels, drawers and guards and check accessible bolts, nuts, screws, terminals and fittings for tightness (only remove front panel of the belt guard).

WARNING

Guards/panels must be replaced prior to energizing unit to reduce the risk of possible serious injury.

W655

2.Replace belt guard front panel on rear of machine.

3.Set Electronic Control for Free Dry, refer to Electronic Control Supplemental Manual for instructions.

4.Start the tumbler by pressing and releasing the START pad. Open the loading door. The cylinder should stop rotating within seven seconds after the door is opened a distance of 1-3/4 to 2-1/4 inches (45 to 57 mm). If it does not, adjust the loading door interlock. Refer to the appropriate paragraph in the Adjustments section of this manual.

5.Start the tumbler and check the burner flame.

6.Load the cylinder with 30 pounds of cotton clothes or clean rags.

7.Check the air flow switch operation by opening the loading door. The heating system should shut off when the loading door is opened a distance of one to 1-1/2 inches (25 to 38 mm).

WARNING

The tumbler must not be operated if the airflow switch does not shut off heating system in step 8. Faulty airflow switch may cause an explosive gas mixture to collect in the tumbler.

W656

The airflow switch operation may be affected by shipping tape still in place, lack of make-up air, or an obstruction in the exhaust duct. These should be checked and the required corrective action taken before attempting to adjust the airflow switch. To adjust the airflow switch refer to appropriate paragraph in the Adjustments section of this manual.

M412060