Installation

Before You Start

Tools

For most installations, the basic tools you will need are:

1

2

3

4

7

6

5

 

D814I

1Wrench

2Screwdrivers

3Pliers

4Socket Wrench

5Teflon Tape

6Level

7Duct Tape

Figure 1

Water

Washer needs two standard 3/4 inch (19.1 mm) water supply faucets with a pressure between 20 and

120 pounds per square inch (138 to 827 kPa). For more detailed information, refer to section on Water Supply Requirements.

Gas

Dryer is equipped for Natural Gas with a 3/8 inch N.P.T. gas supply connection. For more detailed information, refer to section on Gas Requirements.

Location

Place the unit on a solid floor with an adequate air supply. For more detailed information, refer to section on Location Requirements.

Exhaust

Use rigid metal duct and exhaust the dryer to the outside by the shortest route possible.

NOTE: For more detailed information, refer to section on Dryer Exhaust Requirements.

H311I

Figure 2

Electrical

●WASHER

Refer to serial plate for specific electrical requirements. For more detailed information, refer to section on Washer Electrical Requirements.

●ELECTRIC DRYER

Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt, 60 Hertz, 30 Amp, AC single phase electrical supply. For more detailed information, refer to section on Electric Dryer Electrical Requirements.

●GAS DRYER

Dryer needs a 120 Volt, 60 Hertz, 15 Amp, polarized 3-slot effectively grounded receptacle. For more detailed information, refer to section on Gas Dryer Electrical Requirements.

NOTE: 208 Volt heating element is available (as optional equipment at extra cost).

16

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

801539